MATERIAL SAFETY DATA SHEET

HILTI, INC.:
P.O. Box 21148
Tulsa, OK 74121
Ph: 1 800 879 6000
Emergency No.: 1 800 879 4444

PRODUCT NAME: CG200PC Cement-Based Grout

DESCRIPTION: Portland cement based construction grout

INGREDIENTS AND EXPOSURE LIMITS

INGREDIENTS:	CAS NUMBER:	PEL:	TLV:	STEL:
Portland Cement	65997-15-1	10 mg/m3	10 mg/m3	NE
		05 mg/m3
Silicon Dioxide (sand)	14808-60-7	0.1mg/m3	0.1mg/m3	NE
Gypsum	13397-24-5	15 mg/m3	10 mg/m3	NE
		05 mg/m3

PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established. = as total dust. = as respirable dust.

PHYSICAL DATA

FIRE AND EXPLOSION HAZARD DATA

EXTINGUISHING MEDIA: Not Applicable FLAMMABLE LIMITS: Not Applicable

SPECIAL FIRE FIGHTING PROCEDURES: None known FLASH POINT: Not Applicable

UNUSUAL FIRE AND EXPLOSION HAZARDS: None known

REACTIVITY DATA

STABILITY: Stable INCOMPATIBILITY: Strong acids

HAZARDOUS DECOMPOSITION PRODUCTS: None expected

HAZARDOUS POLYMERIZATION: Will not occur.

CONDITIONS TO AVOID: Contact with strong acids can cause violent exothermic reactions evolving toxic gases/vapors (depending on type of acid).

HEALTH HAZARD DATA

KNOWN HAZARDS: None expected from normal use of this product. Excess exposure to dusts by inhalation for extended periods of time may result in the development of pulmonary diseases including pneumoconiosis such as silicosis.

CARCINOGENICITY: IARC has classified respirable crystalline silica (silica sand, CAS 14808-60-7) as Group 2A based on studies of quarry and foundry workers. The nature and intended use of this product does not pose a cancer risk from silica. A properly fitted and NIOSH-approved dust mask will greatly reduce the potential for exposure to silica if dusts are generated during mixing or use.

PRIMARY ROUTES OF EXPOSURE: Dermal. Inhalation.

SIGNS AND SYMPTOMS OF EXPOSURE: Prolonged and repeated exposure to the hands can lead to drying of the skin and dermatitis. Exposure to dusts can lead to breathing difficulty.

MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions.

EMERGENCY AND FIRST AID PROCEDURES

EYES: Immediately flush with plenty of water. Call a physician if irritation persists.

SKIN: Wash with soap and water.

INHALATION: Move victim to fresh air. Call a physician if symptoms persist.

INGESTION: Not normally a route of exposure. Give plenty of water to drink. Seek medical attention. Do not induce vomiting unless directed to by a physician.

OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure.

CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT

VENTILATION: General, i.e. natural or mechanically induced fresh air movements.

EYE PROTECTION: Safety glasses with side shields. Goggles recommended.

SKIN PROTECTION: Cotton gloves recommended.

RESPIRATORY PROTECTION: None normally required with adequate ventilation as noted above. Use a NIOSH-approved dust mask when working in areas where dust is being generated.

PRECAUTIONS FOR SAFE HANDLING AND USE

HANDLING AND STORING PRECAUTIONS: Avoid contact with eyes, skin, or clothing. Wash hands after handling. Store in a dry location.

SPILL PROCEDURES: Sweep up and discard.

REGULATORY INFORMATION

OSHA HAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard.

HMIS CODES: Health 2, Flammability 0, Reactivity 0, PPE A

DOT SHIPPING INFO: Non-regulated.

TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory.

SARA TITLE III, SECTION 313: This product does not contain any toxic chemicals which are subject to reporting under Section 313 of SARA Title III (40 CFR Part 372).

WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations.

HEALTH / SAFETY CONTACTS:
Steve Gerrard (x6309)
Jerry Metcalf (x6704)

The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided.